• Remove the transport brackets before installing the indoor unit.
• Transport brackets cannot be removed if the roof panel is not installed. Install the air conditioner in a place that can support its weight. If the location is not strong enough, the unit may fall and cause injury. Incomplete installation may cause accidents due to dropped units.
The suspension rod in the longitudinal direction is not divided in the center with the size of the ceiling opening.
Therefore, check the relative position of the unit. If the relative position is incorrect, the panel cannot be installed.
After the indoor unit is suspended, consider the pipe / wire connections inside the ceiling and select an installation place, determining the direction of the pipe.
• If the ceiling is already installed, route the refrigerant pipe, the drain pipe, the internal connection wires, the remote control wire, etc. to the location where the pipes and wires are located before suspending the main unit.
• Check the size of the indoor unit and match the size of the ceiling opening and its positions using the manufacturer's standard.
(Secure the frame to the lower side of the indoor unit with the four M5 x 16 l screws).
