• Remove the drive access door by loosening the screw. Connect the wires to the terminals on the control box one by one, as shown.
• Secure the interconnect cables to the control panel with a cable tie (not included with the product).
• Refit the access door to its original position and tighten the screw.
• A disconnect device (circuit breaker) must be installed to properly shut down all power supply lines.
CAUTIONS:
1. Use an individual power circuit specifically for the Air Conditioner. For the connection method, refer to the circuit diagram inside the access door.
2. Make sure that the cable section conforms to the power supply specifications.
3. Check the wires and make sure they are secure after connecting the cables.
4. Be sure to install a grounded, leaking wire to the breaker.